Significantly enhanced breakdown field in Ca1-xSrxCu3Ti4O12 ceramics by tailoring donor densities

Significantly enhanced breakdown field of 24.52 kV cm^?1 as well as noteworthy nonlinear coefficient of 8.11 and low dielectric loss of 0.077 were obtained in Ca_0.6Sr_0.4Cu₃Ti₄O₁₂ ceramic. It was proved from impedance spectra that improved breakdown field was attributed to enhanced grain boundary resistance and elevated Schottky barrier height, which was further found resulting from reduced donor densities in C-V measurements. In addition, it was found that the activation energy originated from oxygen vacancies was increased, indicating the generation of oxygen vacancies was suppressed. Since oxygen vacancies acted as donors in depletion layers, it is reasonable to deduce that the reduced donor density was mainly ascribed to the decreased oxygen vacancies. In conclusion, maximum integrated action of strong solid solution effect and weak Sr-stretching effect was achieved when Sr/Ca ratio is 40/60, leading to greatly elevated potential barrier height and enhanced breakdown field consequently.     

绿色合成型混凝土的弹性恢复机制研究

研究了绿色合成型混凝土的弹性恢复性能,结果表明,在满足安全储备的情况下,可充分利用混凝土材料。     

The impact of inoculum source,inoculum to substrate ratio and sample preservation on methane potential from different substrates

Batch experiments were conducted to evaluate the impact of inoculum sources, inoculum to substrate (IS) ratio and storage conditions on the potential and production rate of methane (CH₄) from different substrates: wheat straw, whole crop maize, cattle manure, grass and cellulose.The results of the test with four inocula and four substrates indicated that inoculum source could have a significant impact on both CH₄ potential (BMP) and the kinetics parameters of different substrates. The two inocula showing the highest BMP and production rates in each period were those coming from a feeding with more than 70% of animal manure under thermophilic conditions. The impact of the IS ratio in the range 0.25–2.5, in terms of g volatile solids (VS) substrate/g VS inoculum, depended on substrate type. Maize silage was more affected to changes in the IS ratio than wheat straw. The optimal IS ratio range for maize was 1.0–1.5, however, a wider IS range can be used in wheat straw (0.5–2.5). The impact of freezing and drying depended on biomass type. Freezing, drying and ensiling of grass increased the CH₄ yield compared to fresh grass. Drying of maize had no impact while freezing reduced the CH₄ potential. Drying and freezing had no impact on straw.     

Difference angle quantization index modulation scheme for image watermarking

In this paper, we propose a new angle quantization index modulation (AQIM) method, called the difference AQIM (DAQIM) method. The proposed method aims to improve the watermarking performance against gain attacks. Unlike the original AQIM method (Ourique et al., Angle QIM: a novel watermark embedding scheme robust against amplitude scaling distortions, in: Proceedings of IEEE International Conference on Acoustics, Speech, and Signal Processing, vol. 2, 2005, pp. 797–800), the DAQIM method quantizes the difference of the two angles instead of the angles themselves. The main advantage of the DAQIM method is to disperse the interference to the watermark signal from one angle to more angles. Thus, the watermark has a higher ability to resist attacks. We perform a theoretical analysis of the document-to-watermark ratio (DWR) based on our proposed method. We show that our proposed method can obtain a lower embedding distortion compared to the AQIM and the gradient direction watermarking (GDWM) (Nezhadarya et al., IEEE Trans. Inf. Forensics Secur., 6(4), 2011, 1200–1213), methods under the same robustness and payload conditions. The experimental results demonstrate that our proposed method outperforms common existing methods in terms of the robustness against various attacks such as the JPEG quantization noise, additive white Gaussian noise (AWGN), cropping effect and mean filtering.     

Direct strain evaluation method for laboratory-based pillar performance

Pillar stability is one of important aspects for underground mines.Generally,the stability of the pillars is evaluated empirically based on case studies and site-specific rock mass conditions in mines.Nevertheless the empirical approach applicability can sometimes be constrained.The numerical-based approaches are potentially more useful as parametric studies can be undertaken and,if calibrated,can be more representative.Both empirical and numerical approaches are dependent on the strength evaluation of the pillars while the strain developing in the pillars is seldom taken into consideration.In this paper,gypsum and sandstone samples were tested in laboratory with different width-to-height ratios(W/H)to adapt the strain evaluation method to the laboratory-based pillars.A correlation was then developed between the strain and the width-to-height ratio for pillar monitoring purposes.Based on the results,a flowchart was created to conduct back analysis for the existing pillars to evaluate their stability and design new pillars,considering the strain analysis of the existing pillars with the W/H ratios modelled.     

Adaptive GLR-, Rao- and Wald-based CFAR detectors for a subspace signal embedded in structured Gaussian interference

The problem of detecting a subspace signal embedded in subspace Gaussian interference and thermal noise is studied in this paper. In this problem, both the signal-independent and signal-dependent interferences are assumed to be present, therefore the overall interference subspace covers the signal subspace. The approach of this paper extends previous works involving either of those two kinds of interferences. A set of secondary data containing only interference plus noise is employed to estimate the interference covariance matrix and the noise power. Three new detectors are designed via the generalized likelihood ratio (GLR), Rao and Wald tests, respectively. Their probabilities of false alarms (PFAs) and detections are analytically derived. The PFAs show that the new detectors have the constant false alarm rate (CFAR) property against the interference and noise. Numerical results show that the new detectors outperform their counterparts for the studied problem. Furthermore, the new detectors are less sensitive to the secondary data size and to the mismatched subspace signal than some other detectors, such as the GLR detector (GLRD), the adaptive matched filter (AMF), the adaptive subspace detector (ASD), etc.     

面向文本数据的正则化交叉验证方法

面向文本数据建模时,交叉验证方法是特征选择及模型比较任务中的常用方法。许多研究表明,文本数据模型的性能估计对交叉验证的数据切分方式较为敏感,不合理的切分方式可能会导致不稳定的性能估计值,使得实验结果可复现性差。该文试图论证基于多次重复(m次)的2折交叉验证,通过引入对训练集、验证集分布差异的约束,所构造的正则化m×2交叉验证方法(简记为m×2 BCV)可以改善模型的性能指标的估计,适宜于模型比较。该文首先针对文本数据引入训练集与验证集分布差异的卡方度量,基于该度量构建数据切分的正则化条件,以最大化模型性能指标的信噪比为目标,给出了满足正则化条件的m×2 BCV的数据切分优化算法。最后,以自然语言处理中汉语框架语义角色标注任务为例,验证了基于m×2 BCV方法的有效性。     

少量有机碳对单级自养脱氮工艺性能的影响

采用序批式生物膜反应器(SBBR),经过4个阶段的培养,快速富集好氧氨氧化细菌(AOB)和厌氧氨氧化细菌(AnAOB),并考察不同低碳氮比对工艺脱氮性能的影响。结果表明,NH4^+-N去除率可达到99%以上,TN去除率可达到90%以上。对应C/N=0、1和2时,反应器出水NH4^+-N和TN去除率分别为99.59%、99.5%、98.47%和93.75%、97.22%、98.11%。说明少量COD的存在,可实现同步硝化-厌氧氨氧化-反硝化,且在一定程度上提高脱氮效率。     

超生雾化降尘研究及应用

为解决某矿破碎筛分车间粉尘污染问题，采用喷嘴雾化理论设计喷嘴雾化降尘实验，并根据实验结果在该矿破碎筛分车间应用了超声雾化降尘技术。实验及应用结果表明：超声雾化发生器的液体雾化装置，气体辅助雾化装置和雾束形成器的几何结构影响喷雾的雾化参数与流量特性，液体雾化器与气体辅助雾化装置影响液体初次破碎与雾化，雾束形成器影响雾滴的二次破碎与约束液束形态；超声雾化发生器的气液比与气液压力比存在幂函数关系，幂指数为-1.09；雾滴粒径越小，雾滴的降尘效率越高，当雾滴D50为23 μm时，雾滴的降尘效率在94%以上；在破碎筛分车间振动筛给料皮带和筛上皮带受料点布置超声雾化发生器，超声雾化发生器开启后，车间内粉尘浓度降低至586～10.54 mg/m3，降尘效率在71.38%以上。     

Effect of Reynolds number and boundary layer thickness on the performance of V-cone flowmeter using CFD

The effect of Reynolds number and boundary layer thickness on the performance of V-cone flowmeter has been evaluated using computational fluid dynamics (CFD). The shear stress transport k-ω (SST k-ω) turbulence model has been adopted for closure. The performance of two V-cone flowmeters with different beta ratios (β) viz., 0.6 and 0.7 for a fixed vertex angle (ϕ) of 60° has been analysed as a function of Reynolds number (Re). The results show that the coefficient of discharge (C_d) increases with Reynolds number in the laminar and transition flow regimes whereas it is nearly constant in turbulent flow regime. From the results, it can be concluded that C_d is independent of Re for values equal to 4000 and beyond. Further, it is also seen that the performance of the V-cone flowmeter is not affected by the upstream boundary layer thickness if the velocity profiles having different boundary layer thickness are extracted from an axial distance of 10D and more are fed at 5D upstream of the meter. However, the meter is sensitive to the extracted velocity profile from an axial distance of 5D and uniform velocity profile being fed at 5D upstream. The value of C_d may be sensitive as a result of the pressure variation due to the obstruction.